Bristol_Jonesey

According to my spreadsheet, TTS-1 was shipped with every version of Sonar from 8 through to Platinum. So if you need it, use Platinum if you've got it and work your old projects from there. BUT - it should work in New Sonar, as it does for me. It just isn't bundled anymore.

This for me has to be the way forward. When I want to edit the Midi, it makes total sense to edit a given event in context with all the others. For this reason I keep all my midi drum hits on the same Midi track

Provided you haven't done anything daft like uninstall CbB, AND you've pointed the scanner in Sonar to the same paths then you should be good to go. You might want to do a reset & rescan and check for excluded plugins

Did you try my method?

TTS-1 definitely DID run on CbB

What the hell? My post needs to be approved by a moderator? What's going on?

You've got the cursor in the wrong position. Put it towards the top of the clip as shown below, then you can drag the highlighted section up/down

Send an email to support@cakewalk.com

You have at the most, 28 days

No. Not possible

There's always Sonar Free Tier to consider. You don't HAVE to pay for the full version

Have you rendered every AS affected clip before trying again?

Assuming you're recording at 24 bit, there is absolutely no need to drive the needle anywhere near the red. Adjust the input so you're peaking at anywhere between -9db & -12dB and you're golden.

Unless it's a fairly decent compressor AND you're 100% confident in your ability to set it up, I'd be inclined to record dry and compress it in your DAW. Once compression is baked into a track, you can't remove it

I'd be inclined to make your own click track, using samples from whatever drum vsti you've got Anything with a sharp attack & decay will work fine and you can place the hits on the grid wherever you want. Use a different sample for accents Groove clip the clip & drag it out for as many measures as you want

No

The Fx button is in the Mix Module of the control bar It doesn't exactly mute all fx, it bypasses them, which does effectively mute them.

Yes, at least for this purpose

It's really important to read the Melodyne manual. Going in blind can and will result in failure. I know from experience

Typo. Meant 2 It's the same Fx bin that appears in Track View. It's not exclusive to the Console

32 bit, yes. 96K depends on whether your interface supports it

Your terminology is a bit misleading Firstly, there are 3 locations for plugins - the Fx Bin & the Pro Channel This applies to Tracks and Busses equally. These can be dis[played in either the Console View or Track View - there is no Console View track bin per se The Pre/post button determines whether the Pro Channel is PRE or POST the Fx bin. See graphic below.

You're blaming Cakewalk because Steinberg installed their driver over yours? Way to go pal. 🤣

That could be a red flag.

Hey, you're right. Never noticed that before. Live & learn eh?