Bristol_Jonesey

You have at the most, 28 days

No. Not possible

There's always Sonar Free Tier to consider. You don't HAVE to pay for the full version

Have you rendered every AS affected clip before trying again?

Assuming you're recording at 24 bit, there is absolutely no need to drive the needle anywhere near the red. Adjust the input so you're peaking at anywhere between -9db & -12dB and you're golden.

Unless it's a fairly decent compressor AND you're 100% confident in your ability to set it up, I'd be inclined to record dry and compress it in your DAW. Once compression is baked into a track, you can't remove it

I'd be inclined to make your own click track, using samples from whatever drum vsti you've got Anything with a sharp attack & decay will work fine and you can place the hits on the grid wherever you want. Use a different sample for accents Groove clip the clip & drag it out for as many measures as you want

No

The Fx button is in the Mix Module of the control bar It doesn't exactly mute all fx, it bypasses them, which does effectively mute them.

Yes, at least for this purpose

It's really important to read the Melodyne manual. Going in blind can and will result in failure. I know from experience

Typo. Meant 2 It's the same Fx bin that appears in Track View. It's not exclusive to the Console

32 bit, yes. 96K depends on whether your interface supports it

Your terminology is a bit misleading Firstly, there are 3 locations for plugins - the Fx Bin & the Pro Channel This applies to Tracks and Busses equally. These can be dis[played in either the Console View or Track View - there is no Console View track bin per se The Pre/post button determines whether the Pro Channel is PRE or POST the Fx bin. See graphic below.

You're blaming Cakewalk because Steinberg installed their driver over yours? Way to go pal. 🤣

That could be a red flag.

Hey, you're right. Never noticed that before. Live & learn eh?

I've never had to create a preview while exporting. The play icons appear whether the project has been exported or not

How does the waveform appear? Does it show 2 (stereo) or 1 (mono)

This is available from the Start Screen. Without opening a project, you can preview by clicking the little play icon

Or, right click an existing one, Rename it, then remap it

You have to add those buttons yourself then map them as described above

Good album.

You'd be better off starting a new topic of your own, rather than resurrecting this one after 5 years.

Gary, could you edit the title of your original post and add *** SOLVED *** to the title Thanks