"Detected a device change"

[Jim Stamper]

All of sudden, on opening an existing project, I'm getting blue dialog boxes in the lower right corner that say something like "detected a device change".

A couple of these dialogs flash up during the open, then disappear. There doesn't seem to be any problem from that point on.

Anyone know what causes this?

As far as I know, I haven't made any device changes or updates

Thanks

[msmcleod]

A damaged USB cable or dirty USB port can cause that.  My USB hub has the sockets pointing upwards (so they collect dust over time), and I occasionally get this when my USB headset gets moved - it's just a sign the HUB sockets need a clean again.

[Andres Medina]

I do have this issue from time to time. I personally use a conventional electronic cleaner in spray to clean the USB sockets (in case you use it, remember to disconnect your PC completely from the power line before performing the cleaning)

[Jim Stamper]

Thank you both. All my connectors & cables were new in November. I haven't made any changes. 

But it's possible something became loose when shifting gear around on the desk. I'll check it out 👍

[Promidi]

Is it also possible that USB power saving kicks in and disconnects some USB devices....?

Personally, I disable all power saving on my PC (It's a tower)

[Jim Stamper]

On 3/31/2023 at 4:33 PM, Promidi said:

Is it also possible that USB power saving kicks in and disconnects some USB devices....?

Personally, I disable all power saving on my PC (It's a tower)

Thanks, Yes I also do that when I first set up a PC.

But not laptops, I've never used a laptop as my DAW.