Bristol_Jonesey

You probably want to take a look at track templates

Just insert a new artic further down the timeline, or extend the length of the last one.

Send an email to support@cakewalk.com to sort out your password

Do ctrl + end to to find out where it thinks the project ends Then select the entire range of tracks between where you want it to end and where it does end Switch on Ripple Edit All Press delete Switch Ripple Edit OFF (Important!)

Have you got Zero Controllers When Play Stops checked?

Check your Windows settings. You cannot change the size of the UI in this version of Cakewalk.

Works fine here. Which parameter(s) are you trying to automate, and how are you trying?

Try WASAPI shared

Well, after much to-ing & fro-ing, I can safely say what you want doesn't exist

You can do that as well

It's easy to configure CV just to show the faders

No, none whatsoever, at least with that specific case

Odd. What version of CbB are you using?

Wait and see

Use 2 monitors. Track View on 1, Console View on the other.

Just to rule out the obvious, is your mouse wired or wireless?

I'd start a new thread of your own. This one is 32 months old.

There's a very good chance your Write Mode is set to Touch Change it to Latch or Overwrite

To the OP, the simple answer is no, waveform displays have to be zoomed one at a time

Do any of you with this problem boot up your pc before your interface is switched on?

Are we talking wired or wireless?

"We"? Do you speak for everyone?

Highlight the section you want to raise/lower by clicking the bar above and between the 2 nodes (highlighted in red below) Then just drag that part of the curve up/down. Keep your cursor in the darker grey area when dragging

If all else fails, I'd try to re-create the project using your existing audio & midi clips.

Do a "save as" to a new location. Make sure "copy audio with project" is checked Same problem? Ok, delete all your meter/key changes and report back