Bristol_Jonesey

Yes, I've seen that before but not since pre-splat days

Using Ripple Edit to solve this is 100% accurate and repeatable, but as stated above, you MUST switch it back off afterwards

A good way to spot any doubled notes is to open up the track in Staff View You can delete the duplicates there

By installing Platinum first you will get all the extra goodies that you paid for. CbB doesn't ship with very much by way of plugins

Make sure you don't have either Ripple edit or Offset Mode engaged

Look in the audio folder where the project is stored in Windows

Bounce to Clip will do the same as Apply Trimming in this instance

That's because it's a compressor, not a limiter

I'm with you on this one Jack There might be the odd scenario when temporarily disabling the tempo map might solve a problem, but the case put forward by the op is a bit weird

CbB is totally free

This because CbB does non destructive editing Just right clip your (narrowed) clip and select Apply Trimming

Those flyout menus look perfectly normal to me

Curious as to what it was you didn't like?

I'd say with the drums Nice songs btw, I like it

Also, once the nodes have been added, you can drag the section upwards with the ctrl key

Set Workspaces to "none" Assuming your current screenset (usually #1) isn't locked, all setting will be retained when saving

Screensets will do this, as will Workspaces I find Screensets a little more intuitive, but your mileage may vary

Have you tried ctrl + z ?

Should all be available in the Cakewalk Command Centre (CCC)

You can't move them

Clipping at track level really makes no difference as you are not clipping your converters ** You can prove it by boosting the input signal to a ridiculous level, and as long as it's brought under control BEFORE it hits your mains, it will not sound distorted Clipping at the main outs is bad and this is what you need to avoid ** nothwithstanding the fact that clipping is bad for gain staging and the effect on plugins further down the chain

You need to render the clip before evaluating it

What's your buffer size?

I use screensets all the time but cannot replicate the problem you describe above Sorry to be of no help ☹️