Do you have an easier/faster way of doing the operation shown in the GIF below? I do this a lot for clip gain and other automation envelopes like the PC EQ HMF Gain envelope shown in the GIF and my way of adding sloped transitions is time consuming. One issue that might not be obvious is setting the envelope level since for things like this unmasking operation I like to make the cut level consistent. But, dragging it down in each instance is tedious and the level increments easily hit vary depending on vertical zoom.
One thing that would be helpful for my workflow is eliminating the duplicate nodes created by the envelope drag up/down operation.
Question
Bill Phillips
Do you have an easier/faster way of doing the operation shown in the GIF below? I do this a lot for clip gain and other automation envelopes like the PC EQ HMF Gain envelope shown in the GIF and my way of adding sloped transitions is time consuming. One issue that might not be obvious is setting the envelope level since for things like this unmasking operation I like to make the cut level consistent. But, dragging it down in each instance is tedious and the level increments easily hit vary depending on vertical zoom.
One thing that would be helpful for my workflow is eliminating the duplicate nodes created by the envelope drag up/down operation.
Edited by Bill PhillipsSolved
Link to comment
Share on other sites
21 answers to this question
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now