How To Setup A Peavey Studiomix In Cakewalk By Bandlab?

[albert williams 2]

Hello, if anyone can help me I would be grateful. I have a Peavey Studiomix, used it a few time on Windows xp with Cakewalk Pro Audio 9 but my software got stolen so now I have Windows 10 and I'm trying to use it with Bandlab Cakewalk.   Thanks in advance.

Edited September 8, 2020 by albert williams
too long

[DeeringAmps 776]

I have a tutorial for installing and setting up the Tascam FW-1884 on my website. (link in my signature)
You can ignore most of it, just jump to setting up the Control Surface.

HTH

tom

check your C drive Program Files\Cakewalk\Shared Surfaces for StudioMix.dll
If its not there we can ask SCook how to get it installed...
 

[albert williams 2]

Hi Deering Amps, thanks for your reply. I check my C drive Program Files\Cakewalk\Shared Surfaces for StudioMix.dll but it did not showed up there

[scook 2,464]

3 hours ago, DeeringAmps said:

If its not there we can ask SCook how to get it installed...

IDK much about controllers and their software.

IIRC the dlls were dropped from SONAR distributions some time ago so they are not part of the CbB installer either.

Here is a KB article that may help https://www.cakewalk.com/Support/Knowledge-Base/2007013438/Control-Surface-Installers

[albert williams 2]

Hi scook, thanks for joining in to help me i appreciate it a lot. So I've downloaded the Cakewalk Control Surface Plugins from the link you've provided but after I extracted it all and run it the following text appears .....Cannot locate the required version of this program on this system, Please install the correct version of the program to use this pack.

 

[scook 2,464]

It may be looking for a version of SONAR.

support@cakewalk.com may be able to help with this.

 

[albert williams 2]

Ok much thanks, I'll give that email address a try. 

[albert williams 2]

Good day, so I was told by support@cakewalk.com that it's the same way as setting up a Studiomix in Sonor and they would help me but they don't have a Studiomix on hand. If anyone has a Sonar manual and could link me pictures of the parts of the manual that shows how to setup a control surface in Sonar that would be amazing. In Pro Audio 9 it use to be a checkbox that you would have to click on in the console view to get a Studiomix working with it. Please and thank you.

[albert williams 2]

I saw a copy of the Sonar manual online, it doesn't say any thing about StudioMix nor how to setup a control surface but I might get Microsoft to do a roll back to Windows 10 version 1511  for me and then try to install the Cakewalk Control Surface Plugins software cause that version of Windows was out the year the Cakewalk Control Surface Plugins software was released, I've managed to get StudioMix preset in Cakewalk By Bandlab but I guess it wouldn't work without the Cakewalk Control Surface Plugins software installed cause Windows would need to recognize it. I hope I don't have to throw my StudioMix in the garbage cause it's to good, anyone have any suggestions?

Edited September 9, 2020 by albert williams

[scook 2,464]

Search this forum for Studiomix

You will likely see other users who have one

They may be able to help

 

[albert williams 2]

Thanks again scook I'll give that a try.

[albert williams 2]

My StudioMix is now up and running on Windows 10 with Cakewalk By Bandlab. Thanks to everyone who helped. 😃