Hi All,
Very interesting topic. I own the Keylab 61 mkII
I downloaded the files, installed them, switched the handshake off and it seemed to work. In the ACT module section on the main screen I see the 'MMCL Mackie Control #1 - 1' is selected. In the status box below I see the text 'Trks 1-8, Mstr 1, Jog:Meas'.
However, when I open the controller/surface properties panel I don't get any presets. Also when I click the ' Configure Layout' button in the bottom righthand corner nothing happens.
I checked the settings in the register, found two references configured for Shared Presets. When I open these folders I get a long list control surface files which are all without extension each approx 20kb so i guess they should show up as presets.
Furthermore, when I save a preset this filesname doesn't show up in any of the two preset folders, nor does it show up on any of the drives that are connected to my PC.
I tried this with the Mackie Control Universal protocol and the HUI (Beta protocol). I've tried everything I could think of but so far no success.
Any thoughts on this?