Steve Moddelmog Posted September 6 Share Posted September 6 Title is pretty descriptive. I have a project that I've worked on off and on since 2017. I made some edits in "new" Sonar this morning and it played just fine. I was done with my session, so I saved it, closed Sonar, and went about my business. When I tried to open it a few hours later, I can see Kontakt starting to load samples and then Sonar shuts down with no warning. I have rebooted and still same situation. So I tried to open it in CbB and it opens and plays just fine. Cannot figure out how CbB is ok with it and Sonar, which the final edits were made in, is not ok. Screenshot below. Plugins are : DR-008 VC-64 BlueVerb DRV-2080 Kontakt 5 NI Replika Ultra Analog VA2 (VST 3) Ozone 6 The project has three audio tracks, and Sonar and CbB are both set to find Audio in the same location. Any thoughts, besides just using CbB instead of Sonar Link to comment Share on other sites More sharing options...
Wookiee Posted September 6 Share Posted September 6 Send this to support@cakewalk.com with the project but don't include an audio. Include the dmp file if you grabbed it. Link to comment Share on other sites More sharing options...
Steve Moddelmog Posted September 6 Author Share Posted September 6 1 hour ago, Wookiee said: Send this to support@cakewalk.com with the project but don't include an audio. Include the dmp file if you grabbed it. Done, except for the dmp file 1 Link to comment Share on other sites More sharing options...
Steve Moddelmog Posted September 6 Author Share Posted September 6 Problem solved, though I don't understand it. I tried loading the project in Sonar in safe mode. The last thing it asked was about loading Melodyne. I said no and it loaded fine. So I went back to it in CbB, discovered there were two very short clips with unrendered Melodyne edits, rendered them, and saved. Now it loads in Sonar. What's strange is (a) it wasn't a problem for CbB, and (b) even stranger, it loaded fine initially in Sonar when I made a few edits this morning (nothing to do with Melodyne or the track that had the unrendered clips) and gave me no error or strange behavior when I saved it. Only when I tried to open it again... 1 Link to comment Share on other sites More sharing options...
Wookiee Posted September 6 Share Posted September 6 @Steve Moddelmog I have found it always best to render any ARA clips irrespective of the ARA plugin, before exiting Sonar or CbB this goes back to when it was first introduced. 1 Link to comment Share on other sites More sharing options...
Steve Moddelmog Posted September 6 Author Share Posted September 6 40 minutes ago, Wookiee said: @Steve Moddelmog I have found it always best to render any ARA clips irrespective of the ARA plugin, before exiting Sonar or CbB this goes back to when it was first introduced. I agree. The clips were so small I didn't notice them, and they are 7 years old... 1 Link to comment Share on other sites More sharing options...
Noel Borthwick Posted September 9 Share Posted September 9 On 9/6/2024 at 4:57 PM, Steve Moddelmog said: I agree. The clips were so small I didn't notice them, and they are 7 years old... This is in the latest version of Sonar? If you pm me the original project file I can take a look. Link to comment Share on other sites More sharing options...
Steve Moddelmog Posted September 10 Author Share Posted September 10 (edited) On 9/8/2024 at 10:11 PM, Noel Borthwick said: This is in the latest version of Sonar? If you pm me the original project file I can take a look. Yes, the August version of Sonar. I have pm'ed the file to you. One thing I noticed that I didn't mention in my message - it has a tab at the bottom next to Console and Piano Roll that says "Loop Construction <Melodyne> Track 1." I don't remember what that was about - I don't recall ever using "loop construction" and I don't think I've ever seen that tab before in any project. Unfortunately this one was started seven years ago and I don't remember what I might have been doing that created that tab. Possibly changing the tempo? But closing the tab in CbB does cause it to crash, even if I first render the Melodyne clips. Thanks for taking a look. Edited September 11 by Steve Moddelmog 1 Link to comment Share on other sites More sharing options...
Noel Borthwick Posted September 13 Share Posted September 13 Yes the problem was related to the loop construction view preview bus. I've fixed the issue for the next release. 5 1 Link to comment Share on other sites More sharing options...
Steve Moddelmog Posted September 13 Author Share Posted September 13 9 hours ago, Noel Borthwick said: Yes the problem was related to the loop construction view preview bus. I've fixed the issue for the next release. Thanks! Link to comment Share on other sites More sharing options...
Noel Borthwick Posted September 28 Share Posted September 28 Hopefully you can confirm this is fixed in the latest Sonar version… Link to comment Share on other sites More sharing options...
Steve Moddelmog Posted September 29 Author Share Posted September 29 On 9/28/2024 at 12:17 AM, Noel Borthwick said: Hopefully you can confirm this is fixed in the latest Sonar version… Yes, it's fixed. Thanks! 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now