Groove Clip/Loop Construction View

[Gary Shore]

Thx again to everyone who posted over on my thread asking about ways of setting up a secondary bass track to use w/the original..

I'd appreciate people's input about something else -been watching a tutorial about the Loop Construction View and although I'm able to set it up and load a clip,the dropdown menu options off the controls at the top are all greyed-out instead of looking like they do in the video.. 

The Groove Clip Inspector is similarly blank...thinking there must be some screen I need to go to to set things up....

Other than playing/looping the clip,everything else is  deactivated for some reason....

Are there some setting adjustments I need to make somewhere so the types of things you're supposed to be able to do are enabled?

Edited November 3, 2019 by Gary Shore

[scook]

Make sure the clip is set up for looping select the clip then either

• hit  CTRL+L,
• check Looping in the Groove Clip properties in the inspector or
• click the Loop button or turning looping on in the Clip menu in the Loop Construction View

[Gary Shore]

Just wanted to update this in case anyone else comes up against this type of situation and is tearing their hair out trying to figure out what's going on-here's what the problem was(from Documentation page explaining the Groove Clip Inspector Properties)

Note: If this control is not available, the selected clip is most likely an AudioSnap clip. A clip can not have Groove Clip looping and AudioSnap enabled at the same time.-

(I had Audio Snap enabled..)