Automation on Bus doesn't work.

[danardf]

Hi Everyone.

I'm trying to record any automation on BUS but it doesn't work.
I can only play.

I think it's a bug because 1 time on 100 that works and when I try again, it's doesn't work anymore.

I installed the latest version , same thing.

Franck

[Bristol_Jonesey]

Works fine here. Which parameter(s) are you trying to automate, and how are you trying?

[Andres Medina]

Also, be sure automation READ is enabled.

[danardf]

@bris

Hi

I just need to play with volume. Read is enabled sure.
I don't know why it doen't work.
I tested with a simple track. It works on it.
If I create an Audio Bus and I'm forwarding the track to this bus.
I enable R W on the automation and when I move up and down the volume, that works now.
Maybe there is something wrong in the project.

I'm started from a fresh project from scratch.

 

Edited December 21, 2023 by danardf

[danardf]

Thanks for your help though

[David Baay]

1 hour ago, danardf said:

I enable R W on the automation and when I move up and down the volume, that works now.
Maybe there is something wrong in the project.

I'm started from a fresh project from scratch.

Are you saying that writing volume automation on a write-enabled bus works on a new project but not on the existing one where you initially tried it?

[Will.]

18 hours ago, danardf said:

Hi Everyone.

I'm trying to record any automation on BUS but it doesn't work.
I can only play.

I think it's a bug because 1 time on 100 that works and when I try again, it's doesn't work anymore.

I installed the latest version , same thing.

Franck

If you are routing the track output to the bus, it should work with no issues. If you're sending the audio track to a bus as an effect, it will act as a send effect. 

[Promidi]

You’re not in offset mode by any chance are you?

Any chance of a full screen screenshot showing the inspector for the bus you want to automate and the control bar visible (specifically the mix Module)?