blend two clip ends

[sadicus]

What are some techniques to fix an annoying "pop" sound on two mismatched clips?
In this case the is no more data to cross fade each clip.

 

Edited March 29, 2022 by sadicus

[sjoens]

Is your E key broke? 

1. Overlap clips at a point where the wave lines match up  & Fade one clip to that point. (pic)

- Then bounce them together. If noise remains sometimes deleting the noise area works. The resulting silence may be masked in the mix.

In your case this might work:

or

2. Use just enough Fade Out/In at ends of both clips, though this will create some silence.

Moving clips a few milliseconds shouldn't affect it too much. If it does, try slip stretching a small area.

Edited March 29, 2022 by sjoens

[tecknot]

Hi sadicus,

I would cut each end at zero crossings and reapply clips.

Kind regards,

tecknot