HELP how to do Multitrack recording with Alesis Multimix 4?

[GDog 07]

I have an Alesis Multimix 4 USB FX with 4 channels 2 stereo and 2 mono (L/R). I am trying to record 2 different mics at the same time and use a separate track for each but when selecting the input Cakewalk only recognizes 1 channel. I tried using ASIO4ALL but it didn't change anything. I looked everywhere and havent found a solution please help

Edited March 15, 2021 by GDog 07

[John Vere]

It says it can do this on the web site I suggest that you look there or in your manual for how to set this up.
I  am assuming it didn’t come with a ASIO. Driver.  
if so you will have to use WASAPI  Mode   That should show all available inputs   If if doesn’t then do your self a favour and buy a real interface. 
or don’t use the USB.  Go to the tutorials sub forum here and watch my video on using on board audio.

but otherwise I think all you need to do is pan each channel left and right and choose the corresponding input for each track 

 

Edited March 15, 2021 by John Vere

[scook]

Do not have the device but just read a few pages about it here https://www.alesis.com/products/view/multimix-4-usb-fx

Often Alesis gear did not have factory ASIO drivers.

The Alesis Multimix 4 is a mixer with a USB port.

Like most mixers, the computer connection is 2 channel. From the features section:

Quote

16-bit, 44.1/48 kHz signal stereo in / stereo out via USB for easy recording and playback

The image in the OP shows what one would expect from a stereo interface

Left 1 = channel 1 from the interface

Right 1 = channel 2 from the interface

Stereo =  both channels 1&2 from the interface