behringer UMC 1820 outputs not showing up

[Andy Clydesdale]

hi. trying to get Sonar Platinum to recognise all the outputs on my UMC 1820. only shows up 2 that are on the front of the rack. Any suggestions? cheers

[57Gregy]

Welcome to the forum.
Go to Behringer | Downloads and get their ASIO driver. Change your driver from MME to ASIO. See if that works.

 

Edited February 11, 2021 by 57Gregy

[John Vere]

Wonder why so many new posts are using old versions of Sonar? Cakewalk by Bandlab is free and is a much updated version of Splat.

ANd always use ASIO mode to show all inputs of an interface. But as Greg said you need to download the correct driver. 

[Andy Clydesdale]

thanks both! got it working now.. john would you recommend Bandlab over Platinum? 

[scook]

Cakewalk by BandLab is an updated version of 64bit SONAR Platinum without most of the 3rd party plug-ins.

BandLab Technologies purchased Cakewalk IP from Gibson.

With a small team of former Cakewalk employees, BandLab released Cakewalk by BandLab using SONAR Platinum source code. Along with providing this forum, they continue to develop and support the DAW.

 

CbB installs as an upgrade to SONAR Platinum.

This means the DAW and its supporting files install in their own folders and the components shared with SONAR are updated to the latest versions. The shared components are backward compatible with SONAR.

After installing CbB both Platinum and CbB will be available.

With Platinum installed all of the content and plug-ins bundled with Platinum may be used in CbB. 

[John Vere]

3 hours ago, Andy Clydesdale said:

thanks both! got it working now.. john would you recommend Bandlab over Platinum? 

Absolutely, Steve has covered everything I would say nicely above. 

There's nothing to loose and LOT to gain. Splat was actually full of bugs. The focus has beed to make Cakewalk super stable and as bug free as possible. They have done a lot of work since the Bandlab takeover and it's all good.