lapasoa

If you want some notes muted in PRV don't you think that is it better and faster to delete all of them?

When I make some major change in a project, I "save as" the project with a number after the project name. It often happens that when I open my last project number, thi is the message that shows up: "A corrupt audio region was detected and padded with silence". I'm almost sure that this is a bug.

It's a very old and very usual story.

Good acoustic guitar, Neumann U87, RME audio interface...and you've got it.

You've got it. Many thanks indeed.

If you want a block of meausures should be repeated for many times as you like, you use copy and paste special. If next time you need to copy and paste a block of measures for once only, you find that paste (not paste special) is not for once only but for many times as it had been used before in Paste special. Very disappointing.

Nothing better than Celemony Melodyne 4.

In my opinion Quick Groups function doesn't work very well or better to say that is difficult to make it work. Sometime it works and sometime it doesn't. What do you think about?

In a project, also if you use only midi clips, at the end you have to save it as project file (cwp). It's better if you use for all your projects a template file with all your preferred settings. In this way every time you open a new project you'll have your preferred settings ready.

Regarding the message "silent buses detected", go to Preferences and then to Audio driver setting and adjust Playback timing master to your sound card. Go to your master bus and in the drop down menu choose your soundcard output.

Aux tracks have created issues for me too.. Sending your signal/signals to a bus is much better.

Quote Scook. Regarding repeated drum bars I think that using paste special is much better than using Groove Looping. In fact with groove looping you'll find difficult and intricate to insert fills somewhere or make some tweaking. These issues don't occur at all with clips made by "paste special".

Nothing better than have a pair of marracas and a good mic.

Using an acoustic guitar, you can record the built in pickup on one track and a miked acoustic on a second track and then listening to them in stereo.

"Until then, the workaround is to insert one measure at a time" Not at all. Simply don't check meter/key changes and tempo changes. and insert time/measures will be fine for shure.

Using past special for obtain more than one paste. And after that using instead normal paste for another tweak. It's really boring to notice that the number of pastes are the same as before when I used paste special.

I just can't understand why Z3TA +2 level is by default so high. When I find some good effect, every time I am forced to lower a lot the level cursor in a very low position that I find very critical. Is there some way to make it more manegeable?

For me the best order is good ear and then creativity

What do you mean with the need to check in with home base?

Instead to speculating about every single VST gain, it would be much better in your mixing to use your ear and your creativity and you'll be fine.

With the new update 2019/09 all my projects sound mono. No pan, no left, no right. All files in the middle. gasp. It was a stupid button checked in my RME souncard.

It's a long time that we all expect that a project really ends were we want because there are a few cases where the song does'nt stop at the project end without any note or something else beyond.

In the consolle (mixer) you can control the mic sensivity and with the fader you can control the mic volume (gain). Good luck.

After many attempts, only after antivirus suspension my update was fine.

When I select whatsoever track bar in the track view, I see in the time ruler that when I finish to select the track number becomes something like a greek alphabet letter. This happens after 2019.07 update.