Jump to content
ron murphy

Using the TH3 mixer and splitter

Recommended Posts

I'm trying to use the splitter in th3 and combine a modern and randall amp together. I wanna pan one to the left and one to the right but for some reason it's only coming out of the one side. The double amp preset has it where it's one amp coming out of each side. One minute it will work and the next it's only the one side. I'm not sure what I'm doing wrong here.845439483_Screenshot(2).thumb.png.c61dc7d62e979cb53a4d383c84a01623.png

Screenshot (3).png

Share this post


Link to post
Share on other sites

Hi ron,

I don't use TH3, but two places I would look at is the output of your effects chain which looks like a single speaker cabinet (unless it is stereo).  Also, is the audio track containing TH3 in mono or stereo?  I have not tested these theories, but I thought either might be a fix.

Kind regards,

tecknot

Share this post


Link to post
Share on other sites

That's all good, I think it's cause I had the guitar panned to the left. Cause when i bring it in center it's fine again... kinda weird. But im new to all this so it might be normal...lop

Share this post


Link to post
Share on other sites
25 minutes ago, ron murphy said:

I think it's cause I had the guitar panned to the left

This would do it. The pan control is after the PC and FX Rack. Here is the signal flow diagram from the help.

Check out the flow in the Track and Bus sections.

Mixing.07.1.png

If you want to layer the amps and pan them together set the mixer in TH3 to mono and use it to blend the two amps before panning the track. The preset in the image above is set up to have one amp on the left and one on the right. To get the desired L/R levels in this case will rely more on controls in TH3 than the track pan control which is a simple stereo balance control.

Share this post


Link to post
Share on other sites

I have this issue too, so I generally just pull up one of the TH3 presets that already has two amps split for a stereo rig, then swap out the amps and cabs I want.  When I try to do it from scratch, it never works....

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now

×
×
  • Create New...