bassface 1 Posted February 26, 2019 Hi all ..im coming from sonar8.5...there i could define my snap to grid resolution down to the tick. FFS how do you do that in Cake bbl? im tearing my hair out Share this post Link to post Share on other sites
scook 2,740 Posted February 26, 2019 The snap resolution drop down in the snap module D in the image below 1 Share this post Link to post Share on other sites
bassface 1 Posted February 26, 2019 ok Thanks scook .. i couldnt see those xtra choices because i have my modules in SMALL display.. is there any way to get to those options other than resizing those modules? Share this post Link to post Share on other sites
bassface 1 Posted February 27, 2019 hello ..further to my original question...i like to keep my tool bar small and minimal,so to get to the extra snap grid settings mean periodically enlarging the whole thing. is there another way of accessing the whole snapgrid module , so i dont have to that. thanks Share this post Link to post Share on other sites
Craig Anderton 709 Posted February 27, 2019 The Medium size will allow access, maybe you could make something else smaller to compensate. However, you can also have an alternate snap value. Normally snap uses the global snap setting. But if you hold down N while specifying a different snap setting, in your case 1 sample or whatever, then if you HOLD the N key while dragging data, the clip or note will snap to the alternate setting. It's important to hold the N key; pressing it momentarily turns snap on and off. Another option is to toggle between the two settings by typing Ctrl+Shift+N. This lets you use two different snap settings even with the snap module set to its smallest size. 1 1 Share this post Link to post Share on other sites
chuckebaby 735 Posted February 27, 2019 5 hours ago, Craig Anderton said: if you hold down N while specifying a different snap setting Personally I have my snap module normal size ATT, but I use this idea ^^^ as well. Quote is there another way of accessing the whole snapgrid module , so i dont have to that. You can also have control bar modules in a collapsed state. Read Here. My advise would be to remove a few modules you don't use much (ACT Module, Screensets Module, exc) Share this post Link to post Share on other sites
ien 9 Posted February 27, 2019 You can get to the snap values in all but small size, even collapsed (hover cursor over the module). You can also get to some (but not all) by right-clicking the toggle button. If Ticks is your secondary goto then set it up as your alternate value like Craig suggested. Share this post Link to post Share on other sites