Astral 11 Posted February 6, 2020 Can Cakewalk Detect Tempo? Thank you. Share this post Link to post Share on other sites
Colin Nicholls 788 Posted February 6, 2020 I recommend reading this post from yesterday 1 Share this post Link to post Share on other sites
chuckebaby 786 Posted February 6, 2020 You need to have Melodyne installed (base version that was available with Sonar Platinum will do). I will say this though, if your looking to get a tempo from a previously sketched midi/audio track, you can always use the tap tempo function and lay out the song similarly. This is what I do for old 4 track songs recorded that I need to reconstruct. Go through bridge, verse, chorus, exc and tap out tempos, write them down then lay out the song. Share this post Link to post Share on other sites
GreenLight 237 Posted February 6, 2020 (edited) 12 hours ago, Colin Nicholls said: I recommend reading this post from yesterday That was a great thread with good info but with an unfortunate cryptic title. The poster of this thread might have seen it otherwise! Edited February 6, 2020 by GreenLight Clarify Share this post Link to post Share on other sites
Astral 11 Posted February 7, 2020 Thank you for your replies. I drag the audio to timeline and it turned red, not blue (the track was red)- is it normal? But then it created a map with different tempos, like 120.1, 119.7, 120.6... This is EDM track I got steams for to remix. I seriously doubt the original track was fluctuating in tempo so much, unless it was some loop they used... The track is actually not that great- dont understand why Armada Records would sign this. But what do I know... Any way- I just set it to 120 and it works, so thank you. It says- mixing audio to tempo- what was it doing? Just analyzing? Share this post Link to post Share on other sites
