2025.11 Early Access Feedback

[Jonathan Sasor]

On 11/22/2025 at 8:05 PM, Greg Wynn said:

Something is odd when I deselect and reselect a plugin.  In my start template I have plugs I used for years each set up in tracks to give quick starting points with different choices.  With this beta when I reselect a plug it sounds like audio gets all phasy.  It only clears if I stop audio and restart the transport.

That's never happened in 20+ years...but hey, it's what betas are for. 


EDIT - Yikes.  I gotta roll this back as this issue is a show stopper for what I'm doing tonight.  

Anyone else ? 

I'm not able to reproduce this in the EA build. Can you confirm if the rollback did make a difference? Can you reproduce the same issue in a new project with one of the stock templates?

[Greg Wynn]

2 hours ago, Jonathan Sasor said:

I'm not able to reproduce this in the EA build. Can you confirm if the rollback did make a difference? Can you reproduce the same issue in a new project with one of the stock templates?

Hey thanks for looking into this.  So I never ended up reverting to an earlier version and did some troubleshooting.

 

1.  I thought it had something to do with ASIO buffer settings and swapped between 1024 and 128 and there was no change.

2.  I took a good look at the plugins that I normally didn’t use in my template and saw I had a UAD reverb (Capital - next drum reverb ever  ).  I disabled it and then re-enable it.  No change.

3. Puttered around for a bit before taking a break and rebooting - and then everything worked normally.  Strange, eh ?

 

I meant to update this thread and didn’t get to it but I thank you for looking into it !

[Heinz Hupfer]

HI:)

 

Tried with "Go", "Go to", "go to time", then in German " Gehe", "Gehe zu", doesn't find anything so I tried a few other commands which can't be found neither!

Shouldn't it find all commands, not just these which are in the menus?

 

As far as I can see only commands from the menus are found.

 

Bassman.

[msmcleod]

48 minutes ago, Heinz Hupfer said:

HI:)

 

Tried with "Go", "Go to", "go to time", then in German " Gehe", "Gehe zu", doesn't find anything so I tried a few other commands which can't be found neither!

Shouldn't it find all commands, not just these which are in the menus?

 

As far as I can see only commands from the menus are found.

 

Bassman.

"Go to time" is translated as "Zu Zeitposition" in Sonar,  so "Gehe" wouldn't find a match for that.

However, the current trigram tokenizer ignores words less than 3 characters, which is why "Zu" didn't find anything. 

This has been fixed for the next update by adding an additional tokenizer.

Searching for "zu", will show the following in the next update:

[Jonathan Sasor]

Please note the EA build has been updated to 31.11.0.065. Please be sure to grab the latest version. Thanks!