Insert Send - Don't Show All Audio Outputs First

[jeff s]

 Since I rarely use the hardware sends option but always use several bus sends in every project and I have an Apollo 16X there's a lot of options to scroll through to get to the Bus(s) or Send Assistant section which takes time which adds up and makes the process less efficient than it was.  Maybe an option to show the hardware output last or have them in a folder or a pop out choice like Send Assistant.

[David Baay]

33 minutes ago, jeff s said:

Since I rarely use the hardware sends

In the mena time, just disable them in Preferences; they can be easily re-enabled when needed.

[jeff s]

12 hours ago, David Baay said:

In the mena time, just disable them in Preferences; they can be easily re-enabled when needed.

Thanks for that suggestion as a work around.  I currently only use (2) stereo pair for monitor mixes on an Apollo 16X along with the virtual L/R, so this would cut it down quite a bit.  As you know, now that they allow external mono sends, each stereo pair shows up as (3) options, multiply that by 16 channels and throw in AES/EBU for each Apollo 16X and it becomes pages long... hopefully there will be an simple option to show/hide within the Insert Send dialog.  Probably not a big deal for folks with a 2 channel interface.