The dilemma of new computers and USB sound cards

[happen135]

For the past decade, I have been using an old computer with Windows 10 22H2 version, CPU:I5-4460, The motherboard is Gigabyte B-85, with 16GB of memory and a frequency of 1666. The graphics card is Gigabyte 750TI 2GB of video memory and the sound card is Roland v-studio700 sound card console kit. It is connected to the computer using USB2.0 and uses CbB of DAW. Everything runs smoothly. However, this configuration of the computer is too low, so a month ago, I assembled a new computer: CPU: I513490F, 10 cores and 20 threads, motherboard is Gigabyte B760M, memory 32GB, overclocking to 3200, graphics card is Gigabyte 1050TI 4G of video memory, power supply is 650W, hard drive is an M2 solid-state 1TB, and another is a mechanical hard drive 4TB. I installed the same Windows as the old computer. After installing the sound card driver on the 10 22H2 system and running CbB to open the previous recording project files, it was found that the sound card had a serious sound explosion (the sound card settings were the same as before). Observing CbB's performance window, it was found that the engine load The value is very high, with a maximum percentage of 700% -900%, and the audio cannot continue to play. My emotions are filled with extreme grief. I spent 8 hours repeatedly installing the system driver, but all my efforts were futile. Suddenly, I thought that there was a windows11 24H2 version of the system in my system USB flash drive, so I installed it. After installing the driver sound card, it was much better. I set the selective pause setting of USB disabled in the power option of the control panel. The minimum processor state and the maximum processor state in the processor power management were both set to 100%. At present, the probability of sound card popping is much smaller. When the number of processing tracks exceeds 30 tracks, there is still a slight pop. For a month, I have searched the Internet every day for answers. Some said that the video card driver contains audio drivers, and some It is said that the new system needs to optimize many projects, but there has never been a positive answer. The new computer is in USB Is the sound card processing worse than an old computer from 10 years ago? I really can't figure it out, and I hope the teachers on our forum can give me a good answer. Thank you in advance!
 

[Starship Krupa]

On 7/20/2025 at 2:22 AM, happen135 said:

the sound card had a serious sound explosion

I don't understand what this means. Did the level increase, did noise come out?

[happen135]

The sound of PIPIPAPA is stuck until it stops playing. What puzzles me is that the old computer can play smoothly, but the new computer cannot. The system and plug-in of the new computer are the same as the old computer, but the hardware is different, which really makes people crash.

[happen135]

20 hours ago, Starship Krupa said:

I don't understand what this means. Did the level increase, did noise come out?

The sound of PIPIPAPA is stuck until it stops playing. What puzzles me is that the old computer can play smoothly, but the new computer cannot. The system and plug-in of the new computer are the same as the old computer, but the hardware is different, which really makes people crash.

[Starship Krupa]

44 minutes ago, happen135 said:

The sound of PIPIPAPA is stuck until it stops playing.

So, noise.

Sorry, I have nothing but the basics, make sure all bit depths and sampling rates match, go into Device Manager and disable all other sound devices, try a different USB jack, etc.

Will it play back Windows sounds? Sounds from other programs? Or is it only ASIO mode that's broken?