Applied Acoustics Strum GS-2 turn off legato hammer-on

[gmp]

Is there a way to turn off the hammer on when I play legato? Or adjust it some?

[Glenn Stanton]

in the Edit mode, you can adjust the volume and tone of the hammer on

 In Strum GS, hammer-ons and pull-offs are triggered when playing in Keyboard mode and
 when legato playing is detected. The two parameters of this module are Amp and Tone. The Tone
 knob is used to set the harmonic content of the excitation produced by the finger moving on the
 string as explained above. Turning this knob to the left results in a smoother sound while turning it
 clockwise results in a sharper sound. The Amp parameter controls the amplitude of the excitation
 generated by hammer-ons and pull-offs

[User 905133]

[post withdrawn (not relevant) after clarification from OP]

Edited Tuesday at 10:51 PM by User 905133
comment / image re: MIDI learn removed

[gmp]

Glenn, I'm getting the best results from putting hammer-on Amp at 10 and tone at 10. If I play 3rds around the middle C area it works ok, but if I play 3rds in the octave above middle C some notes cut off or don't play. It's similar to a monophonic synth. It's like it's running out of notes, yet playing around middle C is fine. Can you try this please.

I have Strum GS-2  v2.4.4  64 bit

Thanks

[Glenn Stanton]

turning the tone down most of the way "softens" it a bit, but i find the keyboard velocity controls whether or not your legato is "clean" i.e. it definitely fades out across notes if you're hitting the keys lightly. which is somewhat akin to how it might work on the guitar, but i could not get it to do a legato with heavier keys (thus keeping some volume) without sounding like i was hammering - so likely a limitation on their modeling engine...

i'm on 2.4.4 64-bit as well.