Move control surface faders to bus

[Soundman32]

I have my control surface (X32) faders working fine on channels.  Is there a way to change the surface to use the buss section instead?

I can right click on the bottom of the console view, and the menu appears "Move Mackie Control - 1 here", but if I do the same on the buss section, nothing happens.

 

[reginaldStjohn]

I have an x32 as well but have not found a way to control the buss channels. There may be a command or a midi message that could be set to one of the X32 soft buttons to change to the busses but I have not figured that out.

[Soundman32]

39 minutes ago, reginaldStjohn said:

I have an x32 as well but have not found a way to control the buss channels. There may be a command or a midi message that could be set to one of the X32 soft buttons to change to the busses but I have not figured that out.

Many years ago, I also had a BCF2000, that had a button to shift to buss faders (which also swapped the X32 to buss faders), but I've long since given that away.  I've looked at many sites that contain Mackie CC codes, but none have that elusive switch code.

[msmcleod]

There was an option added for the Korg nanoKONTROL Studio to allow the scrub button or loop button to be used as a SHIFT key along with the bank up/down buttons to select tracks or buses:

To enable this, you need to check the "Use Scrub + Bank Down/Up to select Tracks/Buses" option in the Mackie Control dialog:

Not saying this will definitely work with the X32, but worth a try.