Digitech RP500

[Robert Hale]

Can this  be used as a recording interface?

https://digitech.com/dp/rp500/

[Byron Dickens]

No.

[reginaldStjohn]

Similiar question here.

[Byron Dickens]

Yeah. Didn't you already ask this question and have it answered?

[Robert Hale]

ok, thanks.

[Robert Hale]

thanks to each of you responding,  especially Lord Tim with a step by step  sequence.

Sorry to have annoyed some of you for continually pursuing my gear and set up questions. I do read everything carefully and try your ideas.

(Does this reply go to each responder to this thread? I don't see a way to respond to one of the group)

Thanks again to all.

[Glenn Stanton]

as a quick note -- reading the manual: https://eadn-wc05-7545739.nxedge.io/wp-content/uploads/2022/09/RP500_OM_EN.pdf

"8. USB Jack
The USB jack connects the RP500 to a computer and provides two purposes. First it is used to 
provide communication between the RP500 and the X-Edit editor librarian software. Second, it is 
used to stream four channels of audio (2 up / 2 back) to and from the computer when using the 
RP500 to record with the included Cubase LE4 recording software. Refer to the RP500 Software 
Installation Guide and Cubase LE4 online documentation on proper setup for this use."

so it's says Cubase, but it might mean that ASIO4ALL could be the "driver" they recommend (which if this is the only IO unit, isn't the worst (RealTek is...)) with the understanding that the latency will not be as good as a quality IO unit would give you.

 

[Robert Hale]

thank you,  Glenn