Can't here the sound

[Tad Strange]

Hi, I'm using the Mackie Onyx Producer 2.2 as the Audio Interface. The first time I plug in the guitar and follow the tutorial, everything works fine, the TH3, the recording, everything is good.
But on the next day, I notice that I can't here the sound after recording anymore, the TH3 also not working.

[reginaldStjohn]

Then you need to trouble shoot a bit. Check the "Devices" to make sure that the Mackie is still selected as the input and output. Check that when you play back you see meters moving. Check that the Master bus and the HW output meters show activity. Then check that the volume on the Mackie interface is up.

Do you have Headphones or Speakers plugged in to the Mackie?

Basically, run through the whole signal path and make sure that the signal is going where you want it to go.

Edited March 25, 2023 by reginaldStjohn

[Tad Strange]

7 hours ago, reginaldStjohn said:

Then you need to trouble shoot a bit. Check the "Devices" to make sure that the Mackie is still selected as the input and output. Check that when you play back you see meters moving. Check that the Master bus and the HW output meters show activity. Then check that the volume on the Mackie interface is up.

Do you have Headphones or Speakers plugged in to the Mackie?

Basically, run through the whole signal path and make sure that the signal is going where you want it to go.

I have the sound coming out from the speaker plugged into the Mackie. Just not from the recording or get effect from the TH3
As you can see, here, the signal is still in, but I can't here anything while playback

 

 

Edited March 26, 2023 by Tad Strange

[57Gregy]

Welcome to the forum.
What is that track's output set to?

[reginaldStjohn]

It also looks like the track you recorded is a stereo track but only one side has audio on it. If you record from a mono source you probably should only select one input to record from.  

[SirWillyDS12]

You have the track "Armed" to record with input echo enabled... You would be monitoring the input signal to the track and your audio clip will be muted with the default Comping methods...