Quits at 'Loading Region FX Data'..Cakewalk won't run

[Murray Webster]

Any solutions, folks?

Thanks!

M

[Murray Webster]

I assume from another thread that there are issues opening Cakewalk projects - over the last few days it was taking up to ten attempts but now none of my projects will open.

Hope there is a fix on the way soon? ☺ 

M

[Murray Webster]

14 hours ago, Murray Webster said:

I assume from another thread that there are issues opening Cakewalk projects - over the last few days it was taking up to ten attempts but now none of my projects will open.

Hope there is a fix on the way soon? ☺ 

M

O...seems to be an issue with my Focusrite Clarett 4Pre Interface...all runs OK if I disconnect it so not sure what that's all about yet!

 

Thanks 

M

[Murray Webster]

Hello again folks .

My 4Pre is working fine with all other software & Focusrite Control shows as connected but Cakewalk quits as per subject line.

Any ideas how to troubleshoot or any suggestions?

Thanks!

M 

[RBH]

Trouble shooting might be as simple as  loading the project while holding the shift key and dismissing the particular effect from loading. Then reload that FX into the region  or clip. At least this will get your project up and running.  I personally try to render any clip or region effects to a new clip. I think region effects are more vulnerable to mishaps or track changes.