LingLing Posted July 9, 2021 Share Posted July 9, 2021 Alright. Basically I had my headphone amplifier plugged in to my computer. I accidentally knocked the USB cable that connected the amp and my pc out and now It's showing me the "Silent Bus" Message. I've tried on different projects and nothing changes. Every time I open the application it gives me a warning message with some instructions. They do nothing though. And this is not an issue with my pc. YouTube, Spotify, and such works perfectly normal. This is pretty annoying cause I worked on a piece for 1 1/2 hours just to have this happen. Link to comment Share on other sites More sharing options...
Glenn Stanton Posted July 10, 2021 Share Posted July 10, 2021 did you check your preference -> audio sections to ensure the interface is selected? for example, your usb interface may have been deselected when you knocked the wire out, and now you just need to reselect it, and then make sure your busses are then using that interface as then may have been set to none when you disconnected. Link to comment Share on other sites More sharing options...
John Vere Posted July 10, 2021 Share Posted July 10, 2021 Did you shut everything off and re start with the cable plugged in to the same USB port it was in before? is this a ASIO interface? Link to comment Share on other sites More sharing options...
LingLing Posted July 11, 2021 Author Share Posted July 11, 2021 Thanks for the help, It works just fine now. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now