Questions about Mackie PRO + SPlat 32-bit

[iRelevant]

Hi. I'm trying to set up a system using the last 32-bit SPlat version and 3 Mackie controllers. MCU + XT + C4 on a W7x64 system.

So far seems to work fairly well, only problem I have is that the XT just clones the channels shown on the MCU. Wonder why that is ? 

I see that the Mackie config file in shared surfaces is dated around 2014, and wonder if there is a point in updating it to the latest version in the Git repository ? 

Regard, Sven

[msmcleod]

To fix this:

• Open up the dialog for the Mackie Control, by selecting "Mackie Control 1" under the Utilities menu (note NOT the XT or C4)
• Click the "Configure Layout" button on the dialog
• You'll now see the channel numbers appear on your Mackie devices:
      - If the XT is to the left of your MCU, turn the 1st rotary knob on the MCU so that it reads "9" for channel 9.
      - If the XT is to the right of your MCU, turn the 1st rotary knob on the XT so that it reads "9" for channel 9.
• Now click the button again on the dialog (it should now say "Press Again When Done")
• Save your preset

Edited February 25, 2019 by msmcleod
Added animated GIF to demonstrate

[iRelevant]

Thank you very much for your help and expertise.  All works fine now, I'm in mixing heaven