Jump to content
  • 0

Trying to turn a loop into a Groove clip - not working


Bob Savage

Question

I  record a 4 bar drum part.

  I create a solid loop using these tracks.

I export the tracks.

I import the newly exported file to it's own track and - I have a working loop in the new track.

When I open the Loop Construction tool and click turn  Looping, I am able to drag out my loop to where I want it.

I see the wave of my loop extended out in that track.

Now here's the problem,

 I can't get new extended version  to play.

If I turn off Looping in the Loop Construction tool or in the Groove Clip drop downs , the new repetitions on my new track disappear. 

I have found no way to get the new, extended drum track to play.

Any advice would be greatly appreciated.

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

  • 0

When you say it won't play, do you mean the transport runs, but the track is silent, or the transport won't run, or...?

To simplify the process, and potentially resolve the issue, try this iin place of export > import > loop construction:

- Bounce the tracks to a new track with Source = Buses, and only the Master bus (or some upstream bus to which they all output) selected.

- Select the new clip, and Ctrl+L to enable Groove Clip Looping.

- Roll it out and check playback.

 

Edited by David Baay
Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
×
×
  • Create New...