Jump to content

davidtongmusic

Members
  • Posts

    46
  • Joined

  • Last visited

Reputation

13 Good

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. ok my bad , i ve to put a meter change at the start of the selection, i can't use the one from 1st bar
  2. crtl+alt+ C selection (meter marker clicked) with 7/4 and 4/4 section; could only paste the clip + markers, all the meter change r missing; tried with/without ripple editing ; advance paste..... no luck, this is definitely not an improvement
  3. yes, its auto saving, even turning it off, all to 0, or add up to 100 mins, it stays the same, same here with bandlab; worsen with Kontakt , and record midi track without arm is ticked...
  4. jazz? fusion? hope You ll like it, some Country music invovled too , if you r allergic....
  5. Hi Fellows i ve a project with like 20 vocal tracks and been asked to bounce to" vocals without reverb", "vocals with reverb",; raw tracks r ok as usual , but i can't get to ve reverb unless i route it to "tracks thru entire mix", it works that way but it took an hr!!! i remember it was an easy task thru "tracks" + bus fx; if not why r the option even there? Thx for concerning
  6. Hi Fellows, if i opened up Master track at track view (sequencer) bottom, whenever i touched a Bus track on console view, its jumps to that track view too, very easy to make mistake when mixing, is there a way to lock it? if anyone understand me??
  7. Thank You Larry; most of them are 1st mix; i know i ll never finish it if i keep listen to it and keep re mixing......
  8. Hi Mark, Thank You; i did came up with few chords, or a line and recorded it to a click, usually not perfect at 1st time , i ll come back and refine it after the image was clear; no i don't use any drums track nor backing i actually wanna play solo , back to very primitive days when i learnt to play the guitar
×
×
  • Create New...