Jump to content
  • 0
Sign in to follow this  
jkoseattle

Memory use oddness

Question

I have a project template which when loaded pretty much maxes out my RAM, about 6 Gb. I get a warning from CbB which I ignore. There are a few dozen EastWest instruments loaded. (Too much, I know.) Anyway, I unload 4 of these few dozen instruments and the memory usage shoots down to about 4 Gb, then when I check a few minutes later having changed nothing, it's down to 2 Gb. When I re-load the instruments I had unloaded a few minutes prior, the memory only goes back a little bit. So now my project has all the same instruments loaded that it had when I first opened it, but the memory usage shows ~2 Gb whereas it was over 6 Gb when I first opened it. Why is that?

 

Share this post


Link to post
Share on other sites

1 answer to this question

Recommended Posts

  • 0

Possibly due to the samples ALL being loaded at launch versus loaded and sitting idle while (after launch).

Im not really sure how Cakewalk interprets this TBH. but it would seem the samples aren't loaded in memory yet once you are adding them to an established open project. Possibly they are sitting in cue awaiting a signal.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×
×
  • Create New...