CW P 1 Posted June 3, 2019 https://www.cakewalk.com/Documentation?product=Cakewalk&language=3&help=ProChannel.04.html Tip: The PC76 U-Type Channel Compressor does not have a dedicated threshold control, but instead has a fixed threshold level and uses the Input control to determine the relative threshold as well as the total amount of gain reduction. To set a specific amount of compression, first turn the Input and Output controls all the way down, adjust the Attack control in order to engage gain reduction, then finally adjust the Input control until the desired amount of gain reduction is achieved. it said that turn the Input and Output control all the way down. But if Input knob is turned all the way down, does it cannot read any signal from original source? I couldn't see VU meter moving when Input is zero. I don't think this old documetation is worng. is there anything i miss? Share this post Link to post Share on other sites
Bapu 2,187 Posted June 3, 2019 Well FWIW, my 76KT (hardware) manual reads pretty much the same. Share this post Link to post Share on other sites