Jump to content
Sign in to follow this  
spiffo

Automation - Drawing LFO Shapes Question

Recommended Posts

I've just got into using the Draw Tool to create Sine, Triangle, etc LFO Shapes in the Automation Lanes which is great!

The Frequency of these LFO's is determined by the Snap Settings but they only go up to one Measure long. I read the Documentation and if I Hold Down CTRL I can double the length of the LFO Shape (half the Frequency). But that means the Maximum Wavelength I can draw is 2 Measures long and I'd like to be able to draw LFO Shapes that are quite a bit longer than that or much lower in Frequency, is that possible?

Share this post


Link to post
Share on other sites

Doesn’t matter whether Snap is On or Off, the Snap Setting still sets the waveform frequency which is great but like I said for me that lower limit to the frequency isn’t low enough!

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×
×
  • Create New...