Jump to content

Lost FX/Tone in Output assign from TTS-1 *** FIXED***


Harley Dear

Recommended Posts

Hi All,

I am puzzled by the loss of tone/FX when you Output assign a track from TTS-1

I need controllable outputs to our Ui24R and one of the instruments I quite like in TTS-1 is Brass1. It has a nice built in ( seemingly ) reverb. I have assigned this to Output 3 and that output is an added Audi track. The sound/tone however is completely flat for some reason. If I reassign the output to 1 which goes to the master, I get the nice reverb FX back, but the problem is I now have no control over it as a separate track ( so the sound guy can change levels if need be when we're playing live ).

I know it's something I either forgot or simply don't know how to set it up properly, but I do like the reverb sound that Brass1 has. I tried adding Sonitus Reverb but it hasn't made any difference.

Ay ideas why I lose those FX by Output assign and how I go about fixing it?

Thanks - Harley -

Lost FX in output assign.jpg

Sonitus reverb added.jpg

Edited by Harley Dear
Link to comment
Share on other sites

OK, a little research and I found that only Output assign 1 has the effects built in - the other outputs don't.

Also, how I was setting up the Sonitus reverb on the Audio Channel ( where Output 3 went to ) was incorrect, but that's now fixed and I have a lovely Brass1 sound back again.

Happy camper am I 

Only FX in output 1.jpg

Link to comment
Share on other sites

  • 2 weeks later...

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
×
×
  • Create New...