OldNick 5 Posted September 17, 2020 I have edited and saved some kits, based on Black Velvet. I do not know what I have done, but somewhow I have "turned off" the cymbals in the kit. AFAICS there are no controls for these instruments. Anyone know what I can try to get them back? Thanks for any help. Share this post Link to post Share on other sites
Glenn Stanton 119 Posted September 17, 2020 (edited) the cymbals are typically routed via the overhead (OH) and room, and perhaps buss (although i tend to mute that most times). so if your OH or room channels are muted, low volume, or redirected from master or not assigned as separate audio channels in your console/track, that's the likely cause. Edited September 19, 2020 by fossile 1 Share this post Link to post Share on other sites
Robert Bone 410 Posted September 20, 2020 If you go into the AD2 user interface, do the cymbals sound when you click on them? Are you routing everything to separate outs, or are you just using the main outs, from the AD2 internal mixer? Bob Bone Share this post Link to post Share on other sites