A new melodyne question

[timboalogo]

This is for the Melodyne included with sonar.

Until today, I used to be able to "Melodyne" a track and use the arrow cursor to drag a note slightly up and down and hear the changes as I did so.

Suddenly, I can only move the note a full note up or down, as in it only moves in 1 semitone increments instead of cents. I still hear the changes mind you and I can use the "correct pitch" macro to make the change. I really liked hearing the change as I made it, especially in combination with the pitch tools.

The algorithm is set at "melodic". I've reinstalled Melodyne 4.2.1.003 to no avail. Very frustrated.

Timbo

[Keni]

I'm not a melodyne expert, but I believe there is a toggle for quantizing to steps that you need to turn off.

 

Edited February 27, 2019 by Keni

[timboalogo]

I'm going to answer my own question, just so anyone else who may run into this gets the answer.

I did not make this change, but the change did occur overnight: under Options -> Pitch Grid, it was set to an option other than "No Snap", which enables what I was ranting about.

I do not recall making this change, but hope this brief foray into YellowDwarf's studio provides an answer for some other poor soul out there in the interweb.

 

Timbo

[chuckebaby]

Yup, this had "Snap" written all over it, its happened to me as well.

[Paul G]

You can also just hit the Alt key to temporarily disable snap as you move a blob.

HTH