Jump to content
Sign in to follow this  
Kenneth Doerbecker

USB drivers with a Behringer XR18

Recommended Posts

CW/BL was working OK until I discovered that if I play back a track that is still armed, the audio gets garbled after a few seconds. If I stop and start it again from the same spot its ok for another few seconds. Discovered that this doesn't not happen if I disarm the track.

Sounded like a typical USB driver issue so I checked and found our BL was using MME. I installed Asio4All and can set the driver up but none of the XR18 channels show up. They do if I set it to MDW but then I get a driver unusable message.

Any thoughts? If you you are using an XR18 what is your setup?

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×