Jump to content

USB drivers with a Behringer XR18


Recommended Posts

CW/BL was working OK until I discovered that if I play back a track that is still armed, the audio gets garbled after a few seconds. If I stop and start it again from the same spot its ok for another few seconds. Discovered that this doesn't not happen if I disarm the track.

Sounded like a typical USB driver issue so I checked and found our BL was using MME. I installed Asio4All and can set the driver up but none of the XR18 channels show up. They do if I set it to MDW but then I get a driver unusable message.

Any thoughts? If you you are using an XR18 what is your setup?

Link to comment
Share on other sites

  • 1 month later...

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
×
×
  • Create New...