Jump to content
  • 0

ASIO Driver causing clicks and pops on project startup


Gaurav Govilkar

Question

Hi,

 

I'm experiencing a strange issue as when I open cakewalk and load a project, it starts creating clicks and pops immediately even before audio is played. Note that the curser on the cakewalk screen keeps loading. I then have to open preferences and select another driver other than ASIO (WASAPI shared), save it and then select ASIO again.

I am on windows 10 in a brand new laptop - 

i7 9750H Processor

16GB RAM | NVidia RTX 2060 Graphics

I am using Native Instruments Komplete Audio 6 Interface.

Please note that I have used Cakewalk on another laptop (i5, 8GB RAM, windows 7) with the same interface and it has worked well without any issues.

Please advice.

Thanks,

Gaurav Govilkar

Edited by Gaurav Govilkar
Link to comment
Share on other sites

6 answers to this question

Recommended Posts

  • 0
On 6/18/2020 at 12:03 AM, Gaurav Govilkar said:

16GB RAM | NVidia RTX 2060 Graphics

What version of Cakewalk are you using?

Have you disabled the high definition audio on the Nvidia card?

If you're not using

Is your PC fully patched.

Are all of your hardware drivers updated (audio and video)?

Note: The latest driver for the Nvidia card is 446.14 

If you're not using your onboard audio for anyhting, consider disabling that as well

If you are using onboard sound as well, make sure the sample rate is set that same as your Audio interface as used in Cakewalk

Have you turned off core parking and set power settings to maximum performance (for AC operation)?

Link to comment
Share on other sites

  • 0

Hi,

Thanks for your response.

Cakewalk version - 2020.05 (Build 039, 64 bit)

Power settings to High Performance.

I have disabled the Nvidia and onboard audio

image.png.7ce83c440a0565ea3e273a1d8f8f8db3.png

 

A large project is now unable to be opened in cakewalk due to the same click-pop issue at project startup. :/

Link to comment
Share on other sites

  • 0
3 hours ago, Robert Bone said:

Try temporarily disabling the device drivers for your WiFi, just before launching Cakewalk, then when done with your Cakewalk session, you can enable the WiFi drivers again.

Tried that. No luck.

The project session looks something like this while trying to open. It wont load properly, but the click/pops keep on coming. the curser keeps on revolving,

image.thumb.png.c3ca6a7f194ffc20bf15b7ff2bae7701.png

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
×
×
  • Create New...